Roof repair in Brenham
Boots, tabs, flashing and decking sections.
2026 Brenham prices
Roofing Cost in Brenham, TX
Call (716) 328-9097 for a roofing price from a Brenham, TX roofer. Small repairs run $150 to $1,900, a single traced leak runs $300 to $1,500, and a full replacement runs $6,000 to $20,000 depending on roof area and covering. Every figure below is a 2026 range rather than a quote. What the tear-off uncovers decides where a real job lands inside it.
Call (716) 328-9097
Calls answered 24/7
- Repairs $150–$1,900
- Replacements $6,000–$20,000
- 2026 ranges
Brenham roofing prices, line by line
The table gives 2026 price ranges for nine roofing jobs and names the factor that moves each one.
| Job | 2026 range | What moves the price |
|---|---|---|
| Pipe boot replacement | $150–$400 | Number of penetrations and roof pitch |
| Flashing repair | $200–$800 | Chimney repointing, run length, metal type |
| Missing or lifted shingles | $300–$900 | Slope area affected and shingle availability |
| Single leak traced and closed | $300–$1,500 | How far the water travelled from the opening |
| Decking sheet replacement | $500–$2,500 | Sheets replaced, at a per-sheet rate |
| Roof inspection, physical | $75–$200 | Pitch, roof area, whether the attic is accessible |
| Asphalt replacement | $5.00–$9.50 per sq ft | Architectural against 3-tab, and decking found |
| Metal replacement | $7.00–$14.00 per sq ft | Screw-down panel against standing seam, gauge, coating |
| Seamless gutters | $6–$22 per linear ft | Trough size, storey height, guards |
Ranges compiled from 2026 Texas and national roofing price guides. A Brenham roof is measured in squares of 100 square feet of roof area, which runs well above the floor area of the house. Nothing here is a quote.
The five things that move a Brenham quote
Two houses of the same size get different numbers for these reasons.
Roof area, not house size
A steep, cut-up roof over a 2,000 square foot house carries 2,800 square feet of covering. Pitch multiplies area.
What the tear-off uncovers
Soft sheathing is priced per sheet and found only after the old covering is off. A named allowance in the quote keeps this honest.
Access
Two storeys, a steep pitch or a tight lot means harnesses, staging and slower work. All three price above the range.
Penetration count
Every pipe, vent, skylight and chimney is a detail that gets flashed. A complicated roof costs more per square than a plain one.
Timing against a storm
Every Washington County crew books out at once after a county-wide event, and prices sit at the top of each range for weeks.
What does a full roof cost on a typical Brenham house?
A 2,000 square foot Brenham house in architectural asphalt runs near $12,000, inside a $6,000 to $20,000 Texas range. The same roof in standing seam metal runs $16,000 to $28,000 and lasts two to three times as long.
The per-square-foot figures do the work. Architectural asphalt sits at $5.00 to $9.50 installed, impact-resistant asphalt at $5.40 to $8.64, screw-down steel panel at $7.00 to $12.00 and standing seam at $8.00 to $14.00.
Roof area is the multiplier people get wrong. A hip roof at a 6:12 pitch over a 2,000 square foot floor plan carries roughly 2,400 square feet of covering, and a 10:12 pitch carries closer to 2,800. Measure the roof, then multiply. The covering comparison sits on metal coverings.
Does insurance change what a Brenham homeowner pays?
A covered claim reduces the homeowner's share to the deductible, which on Texas wind and hail policies runs one to two percent of the dwelling value. On a $350,000 home that is $3,500 to $7,000 before the carrier pays anything.
That number decides whether a claim is worth filing. Bruising on one slope of a newer roof often costs less to repair outright than the deductible, and a paid claim sits on the record at renewal.
Texas law also fixes who does what. A roofing contractor is barred from acting as a public insurance adjuster on property it works on, so the homeowner deals with the carrier and the roofer deals with the roof. What the adjuster examines is covered in what an adjuster looks at.
Prices by job
Full roof replacement
Tear-off through to the ridge cap.
Metal roofing
Standing seam against screw-down panel.
An inspection before a claim
Physical, drone and infrared, priced separately.
Gutter work
Trough and downspout, per linear foot.
Pricing questions
Why do two quotes for the same roof differ by thousands?
The gap is usually decking allowance, underlayment specification and flashing replacement. A quote that reuses old flashing and includes zero decking sheets looks cheaper until the tear-off. Compare the three line items, not the totals.
Is a deposit normal on a Brenham roof job?
A material deposit is ordinary; a large payment before any material arrives is not. Payment tied to delivery and to completed stages is the standard arrangement. Get the schedule written into the scope.
Do prices drop in the off season?
Winter scheduling in Washington County is easier, and material pricing barely moves. The saving comes from crew availability rather than discounted shingles. A roof booked in January avoids the post-storm queue entirely.
How accurate is a price given over the phone?
A phone figure is a range, and a measured quote is a number. Roof area, pitch, layer count and decking condition all need to be seen. Treat any firm price offered sight-unseen as a starting position rather than a commitment.
Want a number for your roof?
Call to reach a Brenham roofer. Have the roof's age and the square footage handy.
Call (716) 328-9097
Calls answered 24/7